Dfi KS210-IMX6 Manual Manual do Utilizador descarregar pdf (Página 35)

www.dﬁ .com

Chapter 5 Mounting Options

Chapter 5

4. Slide the Panel PC through the hole until it is properly ﬁ tted against the panel.

5. Position the mounting clamps along the rear edges of the Panel PC, ﬁ tting them into the slits

that are around the Panel PC.

Slit for mounting

the clamp

Mounting

clamp

White plastic

cap

6. The ﬁ rst and second clamps must be positioned and secured diagonally prior to mounting the

rest of the clamps. Tighten the clamp’s screw using an electric screwdriver until the white

plastic cap touches the panel. Do not over tighten the screws to prevent damaging the Panel

PC. The illustration below shows all clamps properly mounted.

Panel wall

128.60

217.60

Note:

The maximum thickness of your panel’s opening should be 10 mm. Be sure to route

or trim down the thick wall to 10 mm or slightly less for the clamps to recess and

be compatible with your wall or enclosure.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Sem comentários

Dfi KS210-IMX6 Manual Manual do Utilizador Página 35